110cc Single Seater Go Kart Dune Buggy

Some Assembly required! In most cases and depending on which model purchased, it usually takes anywhere from 10min.-40 min. to complete the assembly process of your vehicle. Our vehicles are usually 80% assembled at the factory and fully tested prior to shipping. For packaging purposes, the battery, handle bars, trunk (if included at time of purchase), and mirrors are removed during testing. These items along with the vehicle will be shipped in a protective crate. To complete the assembly of your vehicle, you will need to properly install/assemble the contents included with your vehicle. Depending on the model purchased, you will usually find these items in the storage compartment underneath the seat. For your safety, be sure to check and tighten all screws, nuts, and bolts prior to using your vehicle for the very first time,(and periodically before every ride). Depending on the length of time the scooter has been stored in the crate after factory testing, the carburetor may need some cleaning due to possible sediment build-up. Detailed instructions on how to perform this procedure can be obtained by contacting our tech support team toll-free Monday through Friday 9am-5pm CST at 877-488-9985 or by E-mail at admin@Mopeds.net. In some instances, it may be necessary for your vehicle to be setup by a local service center for proper set-up and tuning, prior to initial use. This service is commonly referred to as PDI (Pre-Delivery Inspection). Be sure to check for adequate engine fluid levels to help ensure that your vehicle will operate safely according to the manufacturers recommended specifications, prior to first use. It is mandatory to have the existing motor/engine oil (known as packing oil) already in your motor/engine, replaced prior to initial use, with conventional Four Stroke Motorcycle Grade (SAE 15W-40 motor oil).
Remember! You are responsible for performing the setup/PDI that a dealer would normally perform. i.e.- installing rear view mirrors, setting up and connecting the battery, checking tightness of all screws, nuts, bolts, changing oil, etc. Items such as lose hardware and parts damaged from loose hardware and components are not covered under warranty. It is advisable to use a thread locking agent such as Loctite on all hardware to help prevent loose of hardware. Occasionally, on some units, it may be necessary to perform other routine checks/adjustments, such as adjusting the setting of the idle speed and fuel/air mixture screws on the carburetor, cleaning of the carburetor, checking to ensure wires are connected properly, adjusting chain slack and alignment (if applicable), in order to achieve optimum performance from your vehicle. We will gladly assist you with any additional technical questions you may have. Monday through Friday 9am-5pm CST at 877-488-9985.  admin@Mopeds.net